![Calder Brothers Mauldin Precision Spray Owner/Operator & Parts Manual Download Page 18](http://html1.mh-extra.com/html/calder-brothers/mauldin-precision-spray/mauldin-precision-spray_owner-operator-and-parts-manual_3382140018.webp)
·
With bar fully extended operator to control 1’ sections of bar on drivers side for
outside 4’. Bar to be 4" incremental control while using the telescoping feature.
·
Electronic switch to control bar sections individually, as well as a gang on off switch
to be located in the cab of the machine.
·
Bar to be equipped with center mount break-away system for protection in collision.
·
Bar to be equipped with hydraulic extend, and raise-lower with adjustable control for
spray bar height stop.
·
Air solenoid valves to have independent check valve on rear of machine to ensure
proper air pressure used in distributor functions.
CAB CONTROLS AND INSTRUMENTS
·
Computer with in-cab operator controls to include
o Gang on/off spray bar
o Individual spray bar section on/off
o 8 minimum presets for spray application including provisions for shot rate, or
distance traveled for shot length.
o Application rate adjustment switch.
o Distance / Volume used reset switch.
o Display Selection switch.
·
In-cab Instrumentation to have illuminated display containing;
o Truck travel speed in Feet per Minute, or Meters per Minute
o Application rate in Gallons per Square Yard, or Liters per Square Meter.
o Pump Rate in Gallons per Minute or Liters per Minute
o Distance traveled (resettable)
o Volume used (resettalbe)
·
Computer rate control system will be hooked directly to the truck engine (same as
truck gauge package i.e. RPM, and Speedometer) to determine ground speed for
application rate. This will ensure maximum accuracy of truck speed. Use of Radar
type sensor is not acceptable.
·
Master Controls on rear of truck to include
o Load / Unload / Transfer
o Tank Circulate
o Hand Spray
o Automatic Clean-out Cycle
o Cab Control
o Burner on/off
o Thermostat Burner Control
o Pump Speed
o Pump Direction
COMPONENT BOXES / FENDERS
·
All component boxes / storage boxes to be weather resistant.
·
Fenders to be black molded with proper mud-flap installation.
Calder Brothers Corporation
Model: Precision Spray
Serial #
944-N-P2C---S-D00000 to Current
Page18
V2.2