d.
Clean out:
or will use this mode to clean out the spray nozzles and bar after the
Operat
job is complete. By pushing the start button the auto clean cycle will
begin. This will take approximately 5-10 minutes. Once the clean out
cycle is complete a horn will sound.
Clean-Out Mode Sequence
1. Wait for S
rn Valve, 3-way to Bar, 2-way to
3.
Pump CCW at eeCleanCCW_RPMa speed to REV-Suction
4.
ction for eeCleanSuckBarT1
2
nOpenBarT2
Close Return Valve, Close 3-Way, Stop the
turns at eeCleanCW_RPMa
W_RPMb
lose Return Solvent Valve, Close Breather
7
steps 2 to 11 one time
lves
e
Hand spray / Unload:
an operator to use the remote spray wand to apply
TART Pushbutton
2. Open Tank Valve, Close Retu
Bar
Turn
the Bar
REV-Su
5. Open the LT-bar for eeCleanOpenBarT
6. Close the LT-bar for eeCleanShutBarT3
7. Open the RT-bar for eeCleanOpenBarT2
8. Close the RT-bar for eeCleanShutBarT3
9. Repeat steps 5 to 8 one time
10. Open BOTH bars for eeClea
11. Close BOTH bars
12. Close Tank Valve,
Pump, Open the Solvent Valves
13. Turn Pump CW eeCleanCWrevsA
speed. This will Circulate the solvent through the bars
14. Close Suction Solvent Valve, Open Breather Valve
15. Turn Pump CW eeCleanCWrevsB turns at eeCleanC
speed. This will Flush the solvent out of the system back into
the solvent tank
16. Stop the Pump, C
Valve
1 . Repeat
18. Stop the Pump, Close ALL Va
19. Cycle Complete, blow HORN
.
This mode allows
liquid. Operator must select speed and direction.
Calder Brothers Corporation
Model: Precision Spray
Serial #
944-N-P2C---S-D00000 to Current
Page34
V2.2
