Cabletron Systems SmartCell ZX-250, User Manual

Page: 30 / 132

2-12 SmartCell ZX-250 User Guide
Switch Configuration Switch Installation and Setup
Figure 2-9 ZX-250 console and network connections
T•
Start the dumb terminal or PC and its terminal emulation software; then turn on the ZX-250 switch.
Q•
As the SmartCell ZX-250 powers up, a series of diagnostic messages appears on the terminal’s
screen.
–•
After the diagnostics are finished, the switch prompts for a password. Enter the default password,
“admin.”
••
0…iÊÃ݈ÍV…Ê«Àœ“«ÍÃÊvœÀÊÍ…iʈ˜vœÀ“>͈œ˜Ê˜iViÃÃ>ÀßÊ͜ʓ>ŽiÊÍ…iÊÃ݈ÍV…Ê>VViÃÈL•iÊÍ…ÀœÖ}…ÊßœÖÀÊ . Í…iÀ˜iÍÊ
˜iÍÝœÀŽ°
U
Switch name
U
IP address
U
Subnet mask
Once you enter these parameters and reboot the switch, you can log off the local console connection. You can perform
all additional configuration over your network using a telnet connection.
2 p›F
Only one console connection is allowed at any time. To reach the SmartCell
ZX-250 through telnet, you must exit the local terminal connection by entering the
exit
command.
NO SYNC
DATA
MON
DIAG
RX DATA POWER STATUS FAIL RESET
TX DATA TERMINAL ETHERNET
1 2 3 4
NO SYNC
DATA
1 2 3 4
NO SYNC
DATA
NO SYNC
DATA
1 2 3 4
C
A
D
B
TEST
ZX-250
Terminal
Ethernet
Hub
Terminal
RJ-45
Port
Ethernet
RJ-45
Port