123
Local Management: Overview, Setup, and Navigation
Configuring a Port
The following describes how to configure a port using the Rate Limiting
Configuration Screen:
1. To enter a Port Type, proceed to step 2. To enter a port number, proceed as
follows:
a. Use the arrow keys to highlight the field (1) below the Port Number field.
b. Type in the port number and press ENTER.
c. Proceed to step 3.
2. To enter a Port Type, proceed as follows:
a. Use the arrow keys to highlight the Port Number field and press the Space
Bar. Port Number changes to Port Type and the field below it changes to
[all 10Mbps enet].
b. Use the arrow keys to highlight the [all 10Mbps enet] field below the Port
Type field.
c. If the port type [all 10Mbps enet] is not the selection needed, press the
Space Bar to select either [all 100Mbps enet] or [all 1Gbps enet].
3. Use the arrow keys to highlight the field below the Priority List field.
4. Select the priority setting(s) for the port as follows:
a. Use the Space Bar to step to a priority setting: ALL, 0, 1, 2, 3, 4, 5, 6, or 7.
Press the M key to mark the desired priority with an asterisk.
b. If more than one priority is to be selected for the port being configured,
repeat step a for each additional selection.
5. Use the arrow keys to highlight the Direction field.
6. Use the Space Bar to toggle to either Inbound or Outbound.
7. Use the arrow keys to highlight the field below the Max Rate: Kbps field.
8. Type in the maximum rate in Kbps (minimum: 500 Kbps, maximum is
dependent on the speed capability of the port).
At least one priority must be marked to create an entry.
NOTE
