Configuration with QuickSET
18
QuickSET Configuration Guide
Wide Area DDS Configuration Window
The Wide Area DDS configuration window is shown in
Figure 15
, below. The following section
explains how to configure the Wide Area DDS interface using QuickSET.
Figure 15 Wide Area DDS Configuration Window
Table 2
shows the line configuration information determined by your service provider. The factory
default settings are in bold.
This section describes the fields in the Wide Area DDS configuration window.
DDS Line Mode —
Displays the DDS Line Mode. The selections for this field are DDS-PRI 56K
(primary) and DDS-CC 64K (clear channel). The default setting is DDS-PRI.
DDS Clock Source —
Displays the DDS clock source. The selections for this field are either
Loop-Timing or Local-Timing. The Loop-Timing setting allows the CyberSWITCH or HSIM to
receive its timing information from the service provider. The Local-Timing setting allows the
CyberSWITCH or HSIM to generate its timing information internally. If DDS-CC 64K was
chosen for the DDS Line Mode then this field must be set to Loop-Timing. The default setting for
this field is Loop-Timing.
Table 2 Telco Configuration Information
Configuration Information
Required by User
Configuration Information
Supplied by Service Provider
DDS Line Mode
DDS-PRI or DDS-CC
DDS Clock Source
Loop-Timing or Local-Timing
DDS Loop Back
No Loop or Line Loop
Summary of Contents for CSX200 CyberSWITCH
Page 2: ......
Page 164: ...Configuration with QuickSET 148 QuickSET Configuration Guide...
