Configuration with QuickSET
124
QuickSET Configuration Guide
When Split Horizons is OFF (disabled) for any of the above protocols, all protocol information
received on that port will be rebroadcast back out that port, for example, to allow other DLCIs
(Data Link Connection Identifiers) on this port, that have not received these packets, to receive this
information. The Modify window shown in
Figure 134
on the previous page, displays after you
have selected an Interface Number and clicked on the MODIFY button.
Advanced IP Routing Options
Redirector Window
The Redirector window shown in
Figure 135
below, displays after clicking on the Redirector...
button in the Advanced Routing configuration window. The Redirector window is used to set up an
IP address for a remote Dynamic Host Configuration Protocol (DHCP) server.
Figure 135 Redirector Window
NAT Settings Window
The NAT Settings configuration window shown in
Figure 136
on the following page, displays
after clicking on the NAT Settings. button in the Advanced Routing configuration window. The
NAT Settings window is used to set up Network Address Translation on Ethernet ports 1 and 2.
Note: If your configurable device uses version 2.01.XX firmware, you can specify any valid
IP Address as the address that you advertise as your “public” IP Address.
If your configurable device uses version 1.00.XX, or version 2.00.XX firmware, your public
IP Address will be the IP Address that you are running Network Address Translation to.
Summary of Contents for CSX200 CyberSWITCH
Page 2: ......
Page 164: ...Configuration with QuickSET 148 QuickSET Configuration Guide...
