Wide Area - 1 and 2 Configuration Windows
QuickSET Configuration Guide
81
Sync Clock Speed —
Displays your configured receive clock speed. The default setting for this
field is 64000 bits per second. Select the down arrow button to make your selection from the list of
clock speeds (if it is not listed, type the value in).
Sync Flow Control —
Displays the source of the Clear To Send (CTS) and the Force Data Set
Ready (DSR) signals.
The CTS signal is an input to the device. The device can either use or ignore the CTS signal.
Clicking on the box indicates that the device ignores the CTS signal from an external DCE (Data
Communications Equipment) and forces the signal high. The off setting indicates that the CTS
signal is received from an external DCE. The default setting is off. The DSR signal is an input to
the device. Clicking on the box indicates that DSR signal is internally forced high. The off setting
indicates that the DSR signal is received from an external DCE. The default setting is off.
Protocol —
T.he Protocol panel lets you select one of four protocols: Point-to-Point, HDLC
(High ‘Level Data Link Control), Frame Relay Point-to-Point, Frame Relay Point-to-Multipoint.
High Level Data Link Control lets you select either Full or Fractional mode for all or half of the
time slots (for a single interface number and alias). Point-to-Point protocol lets you select an
interface number for each time slot. Frame Relay Point-to-Multipoint allows only one interface
number and alias, but allows multiple DLCIs. Frame Relay Point-to-Point allows multiple
interface numbers, aliases, and DLCIs.
Link Management Protocol —
If Frame Relay is the selected protocol, this field displays Q.933
Annex A, T1.617 Annex D, and T1.617 Annex D 1994. The default for Frame Relay is T1.617
Annex D. This field is grayed out and not used for PPP.
DLCI Setup Button —
The DLCI Setup button displays the DLCIs window shown in
Figure 88
. The DLCIs window shows a list of Interface Numbers, Aliases, and DLCIs (Data Link
Connection Identifiers). Use the Add button and the Add DLCI window (
Figure 89
) to make
entries to this table. Use the Delete button to delete the entry highlighted. Click Done when you
have finished.
RS422
RS530 Alt A
RS530 Alt A
9380125
RS422
RS530A Alt A
RS530A Alt A
9380127
Table 5
Sync Port Types
Sync Port Type
Interface
Type
Cable Type
Cabletron
Part Number
Summary of Contents for CSX200 CyberSWITCH
Page 2: ......
Page 164: ...Configuration with QuickSET 148 QuickSET Configuration Guide...
