Bridging and Routing Configuration
QuickSET Configuration Guide
31
Bridging and Routing Configuration
When you have collected all the necessary network information for the WAN, your
CyberSWITCH or HSIM can be configured for inverse multiplexing or bridging and/or routing.
Bridging and Routing Configuration Window
The first Bridging and Routing configuration window shown in
Figure 30
displays after clicking
on the Next>> button at the bottom of the
General Configuration
window.
Figure 31
shows the
Bridging and Routing configuration window for an HSIM-W84 or CSX500.
Figure 30 Bridging and Routing Configuration Window for HSIM-W6
If you are configuring an HSIM, you will have a single External HSIM Network # window in
place of the two External Ethernet 1, and 2 windows at the right of the panel. The panel is identical
in all other respects. The following section describes the fields in the first Bridging and Routing
configuration window.
Inverse Mux (Multiplex) Configuration —
[The CSX200 does not support IMUX] This
function lets you balance your LAN traffic between two or four T1 WAN ports, and is used with
Point to Point Protocol (PPP) or HDLC protocol. QuickSET automatically sets the WAN Frame
Type to Encapsulated Ethernet when you use the Inverse Mux configuration. When you select the
Inverse Mux check box, bridging, IP routing, and IPX routing functions are all disabled. The
WAN device at the other end of the WAN link(s) must be a Cabletron Systems device, capable of
receiving the balanced WAN traffic.
Summary of Contents for CSX200 CyberSWITCH
Page 2: ......
Page 164: ...Configuration with QuickSET 148 QuickSET Configuration Guide...
