Configuration with QuickSET
86
QuickSET Configuration Guide
This section describes the fields in the Wide Area HDSL configuration window.
HDSL Transmit Clock Source —
Displays the HDSL Transmit Clock Source. Click on the radio
button to select either the Slave or Master option. The default setting is Slave.
Protocol —
The Protocol panel lets you select one of four protocols: Point-to-Point, HDLC
(High Level Data Link Control), Frame Relay Point-to-Point, Frame Relay Point-to-Multipoint.
High Level Data Link Control lets you select either Full or Fractional mode for all or half of the
time slots (for a single interface number and alias). Point-to-Point protocol lets you select an
interface number for each time slot. Frame Relay Point-to-Multipoint allows only one interface
number and alias, but allows multiple DLCIs. Frame Relay Point-to-Point allows multiple
interface numbers, aliases, and DLCIs.
Link Management Protocol —
If Frame Relay is the selected protocol, this field displays Q.933
Annex A and T1.617 Annex D. The default for Frame Relay is T1.617 Annex D. This field is
grayed out and not used for PPP.
DLCI Button —
The DLCI Setup button displays the DLCIs window shown below in
Figure 94
.
The DLCIs window shows a list of Interface Numbers, Aliases, and DLCIs (Data Link Connection
Identifiers). Use the Add button and the Add DLCI window (
Figure 95
) to make new entries to
this table. Use the Delete button to delete the entry highlighted. Click Done when you have
finished.
Figure 94 DLCIs Window
Summary of Contents for CSX200 CyberSWITCH
Page 2: ......
Page 164: ...Configuration with QuickSET 148 QuickSET Configuration Guide...
