4
EN
1
Safety instructions
1.1
General safety instructions
The product was manufactured in accordance with
all recognised regulations and technical standards
and was in compliance with the relevant legal re-
quirements when it was put into circulation.
Nevertheless, it can pose a risk of personal injury
or property damage if you do not observe this
chapter and the safety instructions throughout this
documentation.
●
Read this documentation carefully and in its en-
tirety before working with the product.
●
This documentation must be kept accessible to
all users at all times.
●
Always hand over the product to third parties to-
gether with the full documentation.
●
Follow all of the instructions in relation to the
proper handling of the product.
●
If you detect damage to the product or the mains
supply, stop its operation and notify a service
technician immediately.
●
Use only accessories, spare parts and con-
sumable materials that have been approved by
BWT.
●
Adhere to the environmental and operating con-
ditions specified in the “Technical Data” section.
●
Use your personal protective equipment. It en-
sures your safety and protects you from injury.
●
Perform only tasks that are described in these
operating instructions or that you have been
trained to do by BWT.
●
Perform all tasks in compliance with all applica-
ble standards and provisions.
●
Instruct the operator in the function and opera-
tion of the product.
●
Instruct the operator in the maintenance of the
product.
●
Instruct the operator in relation to potential dan-
gers that may arise while operating the product.
1.2
Scope of the documentation
This documentation applies exclusively to the
product whose production number is listed in
chapter 12, “Technical data”.
This documentation is intended for operators,
installers without training from BWT, installers with
training from BWT (e.g. drinking water specialists),
and BWT service technicians.
This documentation contains important information
for fitting the product safely and properly, starting
up, operating, using, maintaining, and disassem-
bling the product, and for correcting simple faults
independently.
Read this documentation in full before working with
the product. Pay particular attention to the chapter
“Safety Instructions”.
1.3
Personnel qualifications
The installation work described in these instructions
requires basic knowledge of mechanics, hydraulics
and electrical systems as well as knowledge of the
corresponding specialist terms.
To ensure that the device is installed safely, this work
must be performed only by a qualified specialist or
a trained person under the guidance of a qualified
specialist.
A
qualified specialist
is someone with specialist
training, knowledge and experience as well as
knowledge of the applicable regulations allowing
them to assess the work assigned to them, identify
potential risks, and take suitable safety measures. A
qualified specialist must comply with the applicable
specialist regulations.
A
trained person
is someone who has been
instructed by a qualified specialist in the tasks
entrusted to them and the potential dangers of
improper conduct and, if necessary, trained and
instructed on the necessary protective equipment
and protective measures.
Summary of Contents for Perla hybrid
Page 58: ...58...
