Bull NovaScale 5xx5, Installation Manual, Page: 91 / 140

2-41
Setup Procedure
Microsoft Windows Setup
Warning:
Most of the options selected and validated during the setup sequence can be modified.
However, special attention is to be paid when selecting and validating the Licensing Mode
(Per Seat / Per Server). If selected and validated, the "Per Server" Licensing Mode option
CAN be modified. If selected and validated, the "Per Seat" Licensing Mode CANNOT be
modified.
1. Check that the Microsoft Windows CD-Rom labeled "TO BE COMPLETED" is ready for use
and that the yellow sticker with the 25-character Microsoft Windows Product Key required
to complete setup is clearly visible inside the cabinet.
2. Select the first Microsoft Windows domain in the
Control
pane and click
Power On
to
power up the domain and associated hardware components.
3. Toggle the local / integrated console from the PAP unit display to MyOperations-1 or
MyOperations-2 or MyOperations-3 or MyOperations-4 display, as required. See
Toggling the Local / Integrated Console Display , on page 2-12.
4. Check Regional, Date/Time, and Time Zone settings under EFI.
5. The setup wizard is launched automatically and guides the Customer and the Customer
Service Engineer through the setup completion procedure (approximately 30 minutes).
Once setup is complete, Microsoft Windows shuts down, the system domain is rebooted
and the server configuration wizard is launched automatically.
Note:
Server configuration is a Customer-specific task and is not performed by the Customer
Service Engineer during installation. Once the system has been fully installed, the Customer
Administrator may launch this wizard to configure and manage Server Roles.
6. Close the server configuration wizard.
7. Shut down the domain and associated hardware components by selecting the
Shut Down
command in the Start Menu .
8. Toggle the local / integrated console from the domain display to the PAP unit display. See
Toggling the Local / Integrated Console Display , on page 2-12.
9. Update Domain Identity Management Parameters :
a. From the Customer Administrator PAM Tree, click Domains
→
Identities .
b. Select the corresponding Domain Identity and click Edit . The Edit Identity dialog
opens.
c. Complete the
Network Name
,
IP Address
, and
URL
fields with the data entered during
the setup completion procedure.
10.Repeat steps 1 to 9 for each pre-installed Microsoft Windows instance.