Buhnen HB 5010, Translation Of The Original Operating Manual

Page: 41 / 142

Set-up / Retrofit
33
7 Set-up / Retrofit
7.1 Removing / Replacing the Housing
Required tools: • Slotted screwdriver 10 mm
Danger of burns
due to hot metal parts, hot melt material, and hot melt material vapors.
Therefore, always wear heat protection gloves during the following work steps.
Figure 7.1/1: Releasing the housing screws
Removing/replacing the housing is only required for maintenance and repair works.
To do so, carry out the following work steps:
1. Turn off the main switch to shut down the tank system.
2. Disconnect the power plug from the outlet to switch the tank system to zero current.
3. Loosen the screws depicted in Figure 7.1/1 (6 pieces) by about 2 revolutions each.
4. Grasp the housing by the lower recessed grips and carefully pull the housing up verti-
cally and off the tank system.
5. Carefully place the housing on a sturdy surface.
Replace the housing in the reverse order. Make sure the tank seal is correctly positioned.
0
I