Buhnen HB 5010, Translation Of The Original Operating Manual

Page: 54 / 142

Accessories
46
10.1.2 Assembly
Figure 10.1.2/1: Assembly of spray-air adapter kit
To assemble the spray-air adapter kit to the tank system, implement the following steps:
1. Insert the supplied fastening screws through the holding plate.
2. Slide the spacer sleeves onto the screws inserted through the holding plate.
3. Screw on the spray-air adapter kit as shown in Figure 10.1.2/1. The corresponding
threaded holes have been provided on the frame of the tank system.
4. Connect the compressed air connections of the heated hoses to the plug nipples (“E”
in Figure 10.1.1/1). If only one heated hose will be connected, then the remaining
plug nipple must be sealed with a blind plug.
5. Connect the quick-release fastener of the compressed air line to nipple “A” (see Fi-
gure 10.1.1/1).
10.1.3 Setting the optimum working pressure
The adjusting wheel “F” is used to set the working pressure (see Figure 10.1.1/1). The
adjustment range is 0 to 3.5 bar.
The optimum working pressure for spray operation is between 1.4 and 3.0 bar.
Determine the optimum working pressure for your use by repeatedly turning the adjusting
wheel and making trial sprays.
The pressure display always shows the current working pressure.