Installation / Initial operation
15
4
Installation / Initial operation
4.1
Set-up / Installation
820 mm
560 mm
Figure 4.1/1: Required space
After unpacking, place the system on a sturdy work surface that will securely bear the
weight of the system (38 kg). Lift the unit only by its frame.
Leave enough room at the sides (about 50 mm all round) to ensure unobstructed air circu-
lation.
Installation space of approx. 200 mm is required at the back to connect the hoses and to
set the pump pressure.
Set up the unit in such a way that it is protected from moisture, vibrations, and strong dust
accumulation. The permissible ambient temperature is 0…40 °C.
Figure 4.1/1
shows the required space.
4.1.1
Electrical connection
A protective conductor outlet with the following values is required for the electrical connec-
tion:
Voltage:
230 V AC
Frequency
50 Hz
Output:
2.9 kVA
Required fuse:
16 A
4.1.2
Mechanical connection (hoses)
Danger of burns!
When connecting the hoses, it is possible to receive burn injuries at the hose
connections.
Therefore, always wear heat protection gloves when doing this work.
Required tool
• 2 open-end wrenches size 19
To connect a hose, carry out the following work steps:
1. Shut down the tank system.
2. Connect the electrical hose connection with the corresponding connection of the tank
Summary of Contents for HB 5010
