6
WS5400RR2
1
Power Button
To power on, connect the power cable and wait for 10 seconds, then press the power button. To power off, press
the power button.
2
Info LED
If there is a status message, the amber info LED will light up. Check the LCD panel to see the status message.
3
Error LED
If there is an error, the red error LED will light up. Check the LCD panel to see the error message.
4
LAN1 LED
When LAN port 1 is connected, this LED glows green. It blinks when the connection is active.
5
LAN2 LED
When LAN port 2 is connected, this LED glows green. It blinks when the connection is active.
6
LCD Panel
This display shows the status of many TeraStation settings. It also displays errors and messages when available.
7
Display Button
Switches between the different display modes. Also, if the TeraStation is beeping, press this button to stop it.
8
Factory Use Only
9
Drive Lock
Open the front panel with the key to replace hard drives or press the reset button.
10
Reset Button
To shut down and reboot the TeraStation, hold down the reset button.
11
Status LEDs
Normally, these LEDs blink green when hard drives are accessed. If a drive fails, its LED will turn red.
12
Factory Use Only
13
Boot Mode Switch
Leave the switch in the HDD position during normal operation. To recover settings, insert the recovery USB drive
Summary of Contents for TeraStation WSS 5000R2
