80
glowing or fl ashing red.
1.
Error LED
Glowing red:
A hard drive in the TeraStation fails.
2.
Status LED
Flashing red:
If you need to remove a drive whose Status LED is fl ashing red, either shut down the TeraStation, or dismount the drive
in the Web Admin interface. Once the TeraStation is shut down, or the drive is dismounted, then it is safe to replace the
drive.
Glowing red:
The malfunctioning drive's Status LED will be glowing red. This drive may be hot-swapped.
Notes:
• Do not unplug a drive whose status LED is not lit red. If you remove the drive without properly dismounting it, data
may be lost or the TeraStation may malfunction.
•
When changing drives, the replacement drive should be a Buff alo OP-HDS series drive of the same size.
•
The TeraStation is fragile. Handle it with care. Do not drop or bump the TeraStation.
•
Use caution when handling the unit in order to avoid personal injury.
•
Never disassemble any parts while you are replacing a hard drive unless instructed to do so in this manual. Any mal-
function or damage caused by disassembling the TeraStation will void your warranty.
•
To avoid damaging the TeraStation with static electricity, ground yourself by touching something made of metal be-
fore handling any sensitive electronic parts.
•
After a drive is replaced, it takes about 30 minutes before normal fi le reading and writing is restored. The Web Admin
interface may not be accessible during this period either.
•
After a hard drive dismounted from the Web Admin interface is removed, its Status LED will be lit green.
