75
Follow the procedure below to remove any previously registered TeraStations.
• To disconnect multiple volumes in a single operation, follow the procedure below.
1. Start the iSCSI Hard Disk Connection Tool.
2. Click [Setup] - [Remove the registered iSCSI Hard Disk.].
3. Select the IP address (port number) of the previously registered TeraStation that you want to remove, and click
[Remove].
This completes the removal of previously registered TeraStations.
Creating and Expanding Volumes
Creating an iSCSI Volume
32 iSCSI volumes are supported. A maximum of 255 volumes can be created. Each individual iSCSI volume can be con-
nected to diff erent computers (a single iSCSI volume cannot be connected to multiple computers).
Notes:
• When an iSCSI volume is deleted, all data contained in the iSCSI volume is erased. Before changing the settings
for the volume, be sure to back up any important data.
• Enable LVM (previous page) to delete or create volumes.
1
In the TeraStation's Web Admin interface, click [Drives].
Note:
Steps 2 to 6 are for specifying and changing the size of the iSCSI-connected area. This is not necessary if using an
iSCSI connection that is based on hard drive or array units, so proceed to step 7.
2
Click
next to [LVM].
3
Select the hard drive where the volume will be created, then click [Enable LVM on Volume].
Note:
If all the hard drives and RAID arrays are set to [Enable LVM on Volume], the online update cannot be used unless
there is at least one LVM volume.
4
The
"Confi rm Operation" screen will open. Enter the displayed number, then click [OK].
