2006 Buell Lightning: Engine
3-37
HOME
29. See
Figure 3-48.
Loosely install the feed oil line that runs
from the lower front oil pump fitting to the rear fitting on
the oil cooler.
NOTE
Depending on the type of crowsfoot being used to torque the
oil lines it may be necessary to remove the oil filter in order to
properly torque certain oil line fittings.
NOTE
See
Figure 3-48.
It is important to maintain an orientation of
approximately 2 o’clock with the rigid part of the feed oil line
running to the oil cooler. Also be aware of the 1/8-1/4 (3.175-
6.35 mm) clearance specified between the feed oil line and
the clutch cable at the front of the crankcase.
30. Verify that the clutch cable and feed line have 1/8-1/4 in.
(3.175-6.35 mm) clearance.
NOTE
When torquing the oil cooler feed and return lines to the oil
cooler, verify that the lines do not twist while torquing.
Figure 3-48. Oil Cooler Feed Oil Line Orientation (Approximately 2 O’Clock) and Oil LIne Clearances
11971b
10501b
1.
Clutch cable
2.
1/8-1/4 in. (3.175-6.35 mm) clearance
3.
Oil line
4.
Feed oil line
5.
Return oil line
6.
Feed oil line to oil cooler
1
2
3
1
3
2
Summary of Contents for 2006LIGHTNING MODELS
