btsr SMART MATRIX TWIST, Operating Manual

Page: 11 / 79

PC
↔
SMART MATRIX
↔
SM-DIN Connection
SMART MATRIX TWIST - 1-1 -
PC
↔
SMART MATRIX
↔
SM-DIN Connection
The following diagram shows the interconnections among: SMART MATRIX Terminal, SM-DIN Sensor
Interface Boards and PC.
The PC is only used for firmware update operations on SMART MATRIX Terminal and SM-DIN
Boards (**).
(*) To connect the sensors, please refer to the following sections:
SMART MATRIX
↔
SM-DIN
↔
IS3.. sensors Connection .
(**) To update the firmware on SM-DIN Boards you must:
- Disconnect cable
{
from Smart Matrix PC-IN connector
-
Disconnect cable
|
from 1
st
SM-DIN Board SM/IN
}
connector
- Connect cable
{
to connector
}
of 1
st
SM-DIN Board
Prior to operate the SMART MATRIX terminal, make sure you have programmed the communication
speed on all the SM-DIN TWIST as well as on CV232/485/9 module.
For more details, please refer to paragraph SMART MATRIX
↔
SM-DIN/PC Interface and to
paragraph “ID and Transmission Speed Configuration on Each SM-DIN Board” within the Section 1.
Sensors
Sensors
Sensors
as alternative