Bticino 335828, User Manual

Page: 34 / 72

34
Remote controlling
3
1
T T P M 12V~
C C 1 2 3 4
IN OUT
335916
1
T T P M 12V~
C C 1 2 3 4
IN OUT
335916
Command setup
The command to be sent to the switchboard is as
follows:
COMMAND = function code + device (n)
The function codes are as follows:
The device code (n) is the number (from 0 to 8) which
identifies the device to be controlled.
✔
In order to know the number and the type of devices connected to
the switchboard, refer to the” memo card” in the last chapter of the
manual (ask your installation technician for the correct selection).
Basic configuration
Expansion modules
ACTIVATION
after the activation, you will hear a
Confirm tone (BIP BIP BIP)
DEACTIVATION
after the deactivation, you will hear a
Confirm tone (BIIIIIIIP)
CHECKING
(only from an external telephone call)
A Confirm tone will be given as an answer
(BIP BIP BIP), if the device is enabled;
otherwise, a deactivation Confirm tone
will be given (BIIIIIIIP),
if the device is disabled
9
9 1
9
9 0
9
9 2
Staircase
lights
Garden
lights
Blinds Watering
system
Boiler
Remote controlling allows you to switch on and off (via
the telephone) electric devices (devices) connected to
the switchboard by selecting simple commands on the
telephone keypad.
The commands can be sent to the switchboard from internal
telephones (extensions) and, when not at home, from the
fixed telephone network or from a cell phone.
The switchboard is able to control one device; by adding
two expansion modules, it is possible to control up to 9
devices.
The operation mode of the devices must be appropriately
configured. See “Installation manual”.