Pg. 45
Speed Sensor Not Displaying Speed:
If after pairing a speed sensor with a compatible Bryton device, it is important to ensure that the correct speed
detection priority has been set:
On Device
1. On your device, navigate to Bike Profile and select the Bike number you would like to use
2. Once a bike profile has been determined, select Speed Source and ensure that “Priority 1” is set to Speed or
Speed/CAD and “Priority 2” to GPS (This will tell the device to first look for speed readings from a sensor before
using a GPS reading for speed).
In App:
*Before trying to change these settings in the app, please ensure that your Bryton device is compatible with this
feature. If this feature does not appear in your app after connecting your device, then it is likely incompatible.
1. In the Bryton Active app, navigate to “Bike Setting” in the “Settings” tab.
2. Select the bike profile you would like to use and enable it
3. Once a bike profile has been determined, select Speed Source and ensure that “Priority 1” is set to Speed or
Speed/CAD and “Priority 2” to GPS (This will tell the device to first look for speed readings from a sensor before
using a GPS reading for speed).
Battery Replacement:
It is recommended to change the battery inside Bryton Speed sensors every 6 months to one year (results may
vary depending on frequency of use). Bryton Speed/Cadence/Heartrate Sensors use the CR2032 battery size.
Incorrect battery size usage will prevent the sensor from operating normally.
To replace the battery, gently twist the back cover of the sensor to the unlock position and remove the cap (being
careful not to bend any of the metal components inside of it). Remove and safely discard the spent battery. Take
the new battery and place the positive side of the battery to face the end cap with the negative end facing toward
the sensor. Gently replace the end cap and turn toward the locked position. Once locked in place, move/use the
sensor until a green blinking light appears.
B. Cadence Sensor Troubleshooting
First-Use Setup:
Ensure that the battery tab has been removed from the battery before first use. Ensuring the back-sensor cover is
in the locked position, mount or hold the sensor and put it in motion (rotating motion). On the sensor a green light
should begin blinking after a few seconds.
Pairing Sensor:
In order to pair the sensor, please follow the steps below:
1.
Power on Bryton device and navigate to the sensor pairing screen.
