Pg. 19
*When trying to pair a sensor with a Bryton device, please be sure to check the type of connection that the sensor
uses and whether it is compatible with the device you are trying to pair it with (ANT+ and/or BLE). This can be
found in the device user manual and on our website.
Battery Replacement:
It is recommended to change the battery inside Bryton Cadence sensors every 6 months to one year (results may
vary depending on frequency of use). Bryton Speed/Cadence/Heartrate Sensors use the CR2032 battery size.
Incorrect battery size usage will prevent the sensor from operating normally.
To replace the battery, gently twist the back cover of the sensor to the unlock position and remove the cap (being
careful not to bend any of the metal components inside of it). Remove and safely discard the spent battery. Take
the new battery and place the positive side of the battery to face the end cap with the negative end facing toward
the sensor. Gently replace the end cap and turn toward the locked position. Once locked in place, move/use the
sensor until a green blinking light appears.
C. Heart Rate Monitor Setup
First-Use Setup:
Ensure that the battery tab has been removed from the battery before first use. Ensuring the back-sensor cover is
in the locked position, snap the Heart Rate monitor on the belt and wear. the sensor and put it in motion (rotating
motion). On the sensor a green light should begin blinking after a few seconds.
Tips:
- Be sure that the Heart Rate monitor band is worn with direct contact to skin.
- If unable to start the sensor or if sensor has difficulty maintaining connection, lightly dampen skin surface at
the point of electrode contact (allow a few seconds for Heart Rate to be detected)
Pairing Sensor:
In order to pair the sensor, please follow the steps below:
1. Power on Bryton device and navigate to the sensor pairing screen.
2. Select [Scan] while wearing the sensor to activate it (the sensor will blink green when powered on)
*When trying to pair a sensor with a Bryton device, please be sure to check the type of connection that the sensor
uses and whether it is compatible with the device you are trying to pair it with (ANT+ and/or BLE). This can be
found in the device user manual and on our website.
Battery Replacement:
It is recommended to change the battery inside Bryton Heartrate Monitors every 6 months to one year (results
may vary depending on frequency of use). Bryton Speed/Cadence/Heartrate Sensors use the CR2032 battery size.
Incorrect battery size usage will prevent the sensor from operating normally.
