Pg. 14
5. Unplug device and power on, allowing device to acquire satellite connection for a few minutes. The map should
then successfully load and appear on the device.
B. Rider 750
In order to manually add a map to Rider 750, please follow the instructions below:
1. Download the desired map zip file from the official Bryton Website. Please unzip it. Please do not rename the
file(s) or change the file extension(s) in the unzipped folder, as this may cause errors to occur.
2. Using the Bryton device’s original USB cable, plug the device into the PC and in the ”Bryton” disk, navigate to
[Bryton>MAP].
3. Copy the unzipped folder and paste in the [Bryton>MAP>Update] folder.
*If there is not enough free space on the device to add the map(s), please remove unnecessary map folders that
are stored in the following locations: [Bryton>MAP>Update] & [Bryton>Map>MapData]. After adding the map file(s),
please ensure that the device still retains at least 100MB of storage space in order to operate properly.
4. After the map file(s) has been successfully added to the device, go to the [Bryton>MAP>Data] folder and delete
all the contents and folders (these will repopulate after first system start-up).
5. Unplug device and power on, allowing device to acquire satellite connection for a few minutes. The map should
then successfully load and appear on the device.
Using Bryton Active App
In order to import a GPX/FIT route into Bryton Active, follow the instructions provided below:
1. Download file onto phone from Website/App (please ensure the file is saved in FIT or GPX format)
2. Go to the location of the file you would like to import into Bryton Active (normally under "Downloads").
3. Press the file and when prompted to choose an app to open the file with, select Bryton Active
4. The Bryton Active app will open and prompt you to name the Route (this may take a minute). Assign a name and
press "Ok" (please note that you will be unable to change the name after imported)
