Bruker VANTEC-1, User Manual

Page: 46 / 143

Hardware Installation for the D8 ADVANCE VÅNTEC-1 Detector User Manual
4 - 12 M88-E01072
Take care not to damage components of the
card or touch the connector edge. The network
card and its components contain
electrostatically sensitive devices. Before
touching the network card, the servicing people
should discharge themselves by touching an
earthed, grounded object.
Figure 4.7 - Insert the network card
6. Replace the case. Secure any screws.
7. Turn on your computer and allow it to boot-
up normally.
8. To complete the installation, go to Section
6.
4.7 Installation of the detector con-
troller using second-generation
indexer boards (AIB2G)
The cabling and configuration of a VÅNTEC-1
running with the second generation of Axis
Indexer Boards (AIB2G) is different than that
mentioned in Section 4.4.3. This section
describes cabling and configuration of a VÅN-
TEC-1 with AIB2G.
4.7.1 Requirements
• 2 Axes Indexer Boards C79298-A3220-
B231 for D8 systems
• 4 Axes Indexer Boards C79298-A3220-
B232 for D4 and D8 systems
• DIFFRAC
plus
Measuring Package Release
2.4.1
• D8 Controller Firmware 3.0
• D4 Controller Firmware 2.0