Brother DCP-7010, Service Manual

Page: 237 / 327

Confidential
9-49
P-3
Unable to print full pages of a document with the “MEMORY FULL” message.
User Check
(1) Press the
Start
key on the control panel to print the data remaining in the printer.
(2) Reduce the complexity of your document or reduce the printer resolution.
NOTE:
This problem may appear if the data is too complex
.
Possible cause Step Check Result Remedy
Main PCB
failure 1 Is it possible to print after
reducing the data of a
document? Yes Replace the main PCB.
P-4
Headers or footers are not printed out even though they are viewed on PC screen.
User Check
Most laser printers have a restricted area that cannot be printed on. Usually the first two lines
and last two lines of text cannot print (leaving 62 printable lines). Adjust the top and bottom
margins in your document to allow for this.
P-5
The printer sometimes prints a couple of characters and then ejects the page.
User Check
(For DOS environment only)
The application printer emulation setting and the printer’s emulation do not match. Check in the
application software which printer you have selected to make sure the printer is set up correctly.
Remember that the printer emulates widely used printer selections:
HP Laser Jet 6P, HP Laser Jet 6P, Epson FX-850, IBM Proprinter XL
Try setting the printer into HP emulation and then select the HP LaserJet 6P printer in the
application software.