Brother BAS H series, Instruction Manual

Page: 81 / 141

CHAPTER 3 PROGRAMMING PATTERNS
BAS H series, Programmer
73
Moving a part of a continuous program in parallel partially
Move a part of a continuous program in parallel to the position before the next feed is started. The following describes
how to move only pattern B in parallel.
1. Carry out step 8 in "Programming procedure" (page
20).
2. Touch .
3. Touch .
4. Use to position the cursor at the outline
of pattern B.
5. When you press the key once, the outline will
change to red lines and it will be selected.
6. Press .
7. Use the jog key to move the cursor to 2''.
8. Press .
Pattern B will move to 2''.
9. Carry out steps 6 and 7 in "Programming procedure"
(page 19, 20).
To set parallel movement in the middle of stitch data,
touch , and then touch , select the sewing
points to move in parallel, and then move the sewing
points.
The sewing points which are moved are connected by
feeding.
(In the example given below, 6-3 which are in
between 2 and 4 are moved to 6"-3".)
2”
1
5
Start point
2
3
4
Pattern A Pattern B
Pattern C
3”
Feed
Feed
5
Pattern A Pattern B Pattern C
3 ”
Feed
Start point
1
2
3
4
6 ”
6
Feed