Brother BAS H series, Instruction Manual

Page: 54 / 141

CHAPTER 3 PROGRAMMING PATTERNS
46
BAS H series, Programmer
Separating an outline at a sewing point
*
When separating outlines at sewing points when the outlines contain component point data, the
component point data will be lost.
1.
Touch
.
2.
Touch
.
3. Touch to set the skipping units (1, 10, 50,
100, 500, 1000, 5000) and code display switching
(Hide code, Show code).
4. Use to move the cursor to the sewing
point in the outline where you would like to
separate the outline.
* You can move the cursor continuously by holding down
the key.
5. Press .
Setting bar tacking at a sewing point
1.
Touch
.
2.
Touch
3. Touch to set the skipping units (1, 10, 50,
100, 500, 1000, 5000) and code display switching
(Hide code, Show code).
4. Use to move the cursor to the sewing
point where you would like to set backtacking.
* You can move the cursor according to the skipping units.
* You can move the cursor continuously by holding down
the key.
5. Touch to set the number of backtack
operations (1 to 9) and the number of backtack
stitches (1 to 9).
* You cannot set backtacking to cross from one outline to
another, or set it at the sewing start point.
If you would like to set backtacking at the sewing start
point, refer to "Adding and deleting backtack stitches
for an outline" on page 35.
6. Press .
* Backtacking will be set in the return direction from the
current sewing point.
No. of backtack
operations
No. of backtack
stitches
Skipping units
Code display
switching
Skipping units
Code display
switching