Brother BAS H series, Instruction Manual

Page: 51 / 141

CHAPTER 3 PROGRAMMING PATTERNS
BAS H series, Programmer
43
Moving a sewing point
1.
Touch
.
2.
Touch
.
3. Touch to set the skipping units (1, 10, 50,
100, 500, 1000, 5000), code display switching (Hide
code, Show code) and method for moving the cursor
(Move freely, Snap to needle point).
* If the method for moving the cursor is set to "Move
freely", the cursor can be moved to any desired position.
* If the method for moving the cursor is set to "Snap to
needle point", the cursor will move to the sewing point.
■ Selecting continuous sewing points for editing
4. Touch to set the selection method to "Range
select".
5. Use to move the cursor to the start point
for the range that you would like to select.
* You can move the cursor according to the skipping units.
* You can move the cursor continuously by holding down
the key.
6. Press .
7. Use to move the cursor to the end point
of the range that you would like to select. The sewing
points will change to red, and the points from the start
point to the end point will be selected.
* You can move the cursor according to the skipping units.
* You can move the cursor continuously by holding down
the key.
8. Press once, and then use the jog key to move
the cursor to the place where you would like to
move the component point.
9. Press .
■
Manually selecting component points for
editing
4. Touch to set the selection method to
"Manual select".
5. Use to move the cursor to the sewing
point that you would like to move.
* You can move the cursor according to the skipping units.
* You can move the cursor continuously by holding down
the key.
6.
When you press the key once, the sewing point
will change to red and it will be selected.
When you press the
key once, the selected
sewing point will be unselected.
7. If there is more than one sewing point that you would
like to move, repeat steps 5 and 6.
*
To select all outlines
Hold down to select all sewing points in an
outline.
* To unselect all outlines
Hold down to unselect all selected sewing
points.
8. Press once, and then use the jog key to move
the cursor to the place where you would like to
move the component point.
9. Press .
Skipping units
Code display
switching
Selection method
Skipping units
Code display
switching
Selection method
Skipping units
Code display
switching
Selection method
Method for
moving the cursor
Method for
moving the cursor
Method for
moving the cursor