8
84
NOTE:
Muffler tamper bracket screw also captures
cylinder heat shield.
10. Start three hex flange screws with lock washers
to fasten wire guard or stamped guard to muffler.
Tighten screws to
80-110 lb-in
(9-12.4 N-m).
11. If equipped, install muffler deflector/spark arrester as
follows:
A. Orient muffler deflector as noted before removal.
NOTE:
Muffler deflector is installed in either the 9
o'clock or the optional 6 o'clock position.
B. If stamped guard, start three screws to install
spark arrester and muffler deflector. Tighten
screws to
25-35 lb-in
(2.8-4 N-m).
C. If wire guard, install single screw to fasten muffler
deflector/spark arrester to muffler. Tighten
screw to
8-12 lb-in
(0.9-1.4 N-m).
125
Not for
Reproduction
Summary of Contents for Vanguard 10V300
