7
71
A. Tighten screws to
65-93 lb-in
(7-11 N-m) using
the sequence shown in Figure 96.
B. Tighten screws to
130-186 lb-in
(15-21 N-m)
using the sequence shown.
C. Final tighten screws to
194-278 lb-in
(21.9-31.4
N-m) using the sequence shown.
NOTE:
Failure to step-torque screws in the proper
sequence may result in gasket leaks or cause the
crankcase cover to warp.
35. Rotate crankshaft to check for binding.
36. See Figure 97. Check crankshaft end play as follows:
A. Mount base of dial indicator to crankcase or
crankcase cover.
B. Set the indicator contact point on the end of the
crankshaft.
C. Firmly push opposite end of crankshaft as far as it
will go while rotating it back and forth.
D. While still pushing on crankshaft, zero dial
indicator gauge.
E. Firmly pull crankshaft as far as it will go while
rotating it back and forth.
F. While still pulling on crankshaft, note the reading
of the dial indicator gauge.
G. Verify that end play is
0.004-0.014 inches
(0.12-0.35 mm), or
0.004-0.012 inches
(0.12-0.30 mm) if engine is used in a pump
application.
H. Repeat the procedure to verify the reading.
97
98
I. If end play is not within specification, replace the
crankcase cover. If engine is used in a pump
application, remove crankcase cover and add or
remove shims as necessary.
37. Install high mount dipstick and dipstick oil plugs into
crankcase cover.
38. If
not
equipped with stator, move to step 39. If stator
equipped, proceed as follows:
A. See Figure 98. Orient stator, so that wires are at
the top and facing the crankcase. Route wires
through opening (
A
) in crankcase.
B. Start four hex flange screws (
B
) to fasten stator
to crankcase. Alternately tighten screws to
15-25
lb-in
(1.7-2.8 N-m) using a crosswise pattern.
C. See Figure 99. Tightly pull stator wires through
opening in crankcase, and then keeping wires
tight, route between ribs at top of crankcase.
Push down on wires, so that they are snugly
seated against casting.
NOTE:
Through contact with the governor lever,
link, or springs, loose wires can interfere with
governor operation.
Not for
Reproduction
Summary of Contents for Vanguard 10V300
