4
27
6. Remove breather hose (
I
) from port on air cleaner
base.
7. Remove two hex flange nuts (
J
) to release air cleaner
base from carburetor mounting studs.
8. Remove gasket (
K
) from two pins next to mounting
flange of air cleaner base. Discard gasket.
9. Remove duckbill air valve (
L
) from air inlet port on air
cleaner base.
Low Profile Air Cleaner (If Equipped)
1. See Figure 25. Move latch to unlock air cleaner cover
(
A
), and push in side tabs to release from air cleaner
base (
B
).
2. Remove duckbill air valve (
C
) from air inlet port on air
cleaner cover.
3. Remove air filter cartridge (
D
) from air cleaner base.
4. Remove foam seal (
E
) from air cleaner cover.
5. Inspect adhesive foam spacer (
F
) in air cleaner
cover. Remove and discard foam spacer if damage or
general deterioration is evident.
6. Remove two hex flange nuts (
G
) to release bracket
(
H
) from standoffs (
I
).
7. Remove two standoffs from carburetor studs.
8. Remove hex flange screw (
J
) to release trim panel
(
K
) from control bracket.
9. Remove hex flange nut (
L
) from inside carburetor
mounting stud. Remove trim panel.
10. Remove bottom support bracket screw (
M
) from
crankcase to release air cleaner base (screw also
captures cylinder heat shield and blower housing).
11. If necessary, loosen screw with hex nut (
N
) on bottom
support bracket.
12. Remove screw (
O
) to release air cleaner base from
cylinder head (screw also captures cylinder heat
shield).
13. Remove two hex flange nuts (
P
) from carburetor
mounting studs. Remove air cleaner base.
14. Remove gasket (
Q
) from two pins next to mounting
flange of air cleaner base. Discard gasket.
25
Not for
Reproduction
Summary of Contents for Vanguard 10V300
