8
94
137
Final Instructions
1. Install oil drain plug(s) with sealing washer(s) and
tighten to
140-200 lb-in
(15.8-22.6 N-m).
2. Add engine oil. See
SECTION 2 - MAINTENANCE,
CHANGE ENGINE OIL/CHECK ENGINE OIL LEVEL,
steps 7-15.
3. Fill fuel tank with fresh gasoline.
4. Install spark plug wire onto spark plug terminal.
5. Start and run engine. Check for oil and fuel leaks
while engine is running.
Set Idle and Top No-Load Speeds
1. Obtain the Top No-Load Speed for the engine.
Proceed as follows:
A.
Dealers:
See
www.thepowerportal.com.
B.
Consumers:
Contact your local Briggs & Stratton
authorized service dealer.
NOTE:
Have your complete model-type-trim
number and code number in hand.
2. See Figure 137. Obtain Digital Tachometer and Hour
Meter (Part No. 19598) (
A
). Proceed as follows:
Not for
Reproduction
Summary of Contents for Vanguard 10V300
