5
38
TOP END DISASSEMBLY
43
1. See
SECTION 4 - REMOVE EXTERNAL
ASSEMBLIES.
2. See Figure 43. Remove two hex flange screws (
A
) to
release heat shield (
B
) from cylinder head (
C
).
NOTE:
A third hex flange screw to the engine base
was removed with the blower housing.
3. Remove hex flange screw (
D
) to release heat shield
(
E
) from cylinder head.
NOTE:
A second hex flange screw was removed with
the blower housing, while a third screw was removed
with the control bracket.
4. Thoroughly clean exterior surfaces of engine prior to
disassembly. Proceed as follows:
NOTE:
Dirt caked on cooling fins and other areas can
fall into cylinder bore or stick to subassemblies as
parts are removed. Abrasive particles can damage
machined surfaces and plug oil passageways.
Not for
Reproduction
Summary of Contents for Vanguard 10V300
