Briggs & Stratton Vanguard 10V300, Repair Manual

Page: 103 / 112

8
97
5. Install Z-fitting of cable into hole in throttle control
lever ( D ).
6. Loosen hex screw ( E ) on air cleaner elbow. Capture
cable sheath in casing clamp. Tighten screw.
7. Exercise the throttle control lever to verify that lever
and cable move freely without sticking or binding.
Right
1. See Figure 142. Remove black knob ( A ) from throttle
control lever, if installed. For best results, tap knob
from behind using a flat punch and soft mallet.
2. Move the throttle control lever ( B ) to the FAST
position.
3. Verify that nut ( C ) is loose (1/2 turn from tightened
position).
4. Install air cleaner. See AIR CLEANER in this section.
142
5. Remove top hex flange screw on rewind starter.
Install screw capturing casing clamp bracket ( F ).
Tighten screw to 25-35 lb-in (2.8-4 N-m).
6. Install Z-fitting of cable into hole in throttle control
lever ( D ).
7. Loosen hex screw ( G ). Capture cable sheath in
casing clamp. Tighten screw.
8. Exercise the throttle control lever to verify that lever
and cable move freely without sticking or binding.
Fixed Speed Control (No Wire Cable)
1. Remove air cleaner. See SECTION 4 - REMOVE
EXTERNAL ASSEMBLIES, AIR CLEANER.
2. See Figure 143. Move the throttle control lever ( A ) to
the FAST position.
3. Tighten screw ( B ) on bellcrank to 25 lb-in (2.8 N-m).
4. Remove the control link ( C ), if installed.
5. Install air cleaner. See AIR CLEANER in this section.
143
Not for
Reproduction