Briggs & Stratton Vanguard 10V300, Repair Manual

Page: 38 / 112

4
32
33
Carburetor
1. See Figure 34. Using a 4 mm hex socket, alternately
loosen and remove two carburetor studs ( A ). If end
of stud will not accept a 4 mm hex socket due to
damage or wear, proceed as follows:
A. Retrieve the two hex flange nuts removed from
the studs during air cleaner removal.
B. Thread first nut onto stud upside down.
C. Thread second nut onto stud right-side up until it
makes firm contact with the first.
D. Rotate inside nut in a counter-clockwise direction
until stud is loose.
E. Remove stud from cylinder head. Remove hex
flange nuts from stud.
F. Repeats steps 1(B) thru 1(E) to remove second
stud.
2. Draw fuel hose ( B ) out from between blower housing
and crankcase fuel tank flange.
3. Remove carburetor ( C ) and carburetor gasket ( D ).
Discard gasket.
4. Release spark plug wire and stop switch wire from
slot in carburetor adapter ( E ).
5. Remove carburetor adapter and carburetor adapter
gasket ( F ). Discard gasket.
34
Rewind Starter
1. See Figure 35. Remove three hex flange screws ( A )
to release rewind starter ( B ) from blower housing.
Not for
Reproduction