Boston Whaler 210 Montauk, Owner'S Manual

Page: 79 / 113

3-10 210 Montauk
Section 3 • Systems & Components Overview & Operation
R
Raw Water Washdown (Option)
The raw water deck fitting is located on the port
side of the motorwell. A 3.5 GPM (13 LPM) pump
supplies seawater to the deck fitting. The fitting
allows for connection of a common garden hose.
There is a cap that is tethered to the fitting and should
be on the connection when it is not in use.
Maintenance
Maintenance of the raw water system will require you
to check the fittings and hoses for system integrity
to prevent leaks. The system should be run at least
every other month to keep the pumps impellers in
good condition. Clean the seacock intake(s), located
on the bottom aft of the hull on the port and starboard
sides, of any debris or build-up when the boat is in
dry-dock or trailered.
Operation
The raw water washdown pump is activated by the
“RAW WATER” switch on the optional console
switch panel (See figure 2.12.2).
Raw Water System (Option)
Fig. 3.10.1
1
2
RAW WATER PUMP
TO WASHDOWN DECK FITTING
LIVEWELL THRU-HULL DRAIN/SEACOCK (OPTION)
WASHDOWN DECK FITTING
RAW WATER INTAKE SEACOCK
3
The seacock for the pump must be in the OPEN
position before using. The seacock can be accessed
through the motorwell hatch.
The seacock which supplies raw water to the
washdown pump will vary depending on how your
boat is equipped.
4
5
6
LIVEWELL INTAKE SEACOCK (OPTION)
TO THRU-HULL DRAIN
MOTORWELL
LEANING POST LIVEWELL (OPTION)
7
1
2
3
4
5
6
7
4
8
9
8
9
ATTENTION
The seacock must be in the open position when
livewell is in use. Running the pump dry may
cause damage to the unit.