Boston Whaler 210 Montauk, Owner'S Manual

Page: 92 / 113

4-5
210 Montauk
Section 4 • Electrical System
R
Use of higher amperage fuses or breakers is a
fire hazard.
Use fuses and breakers having the same amperage
rating as the original or as specified.
!
WARNING
a circuit breaker trip repeatedly, have a qualified
electrician determine and correct the cause of the trip.
In the event it is necessary to replace a breaker, use
only the same amperage as the original. If a breaker
is replaced with one of lower amperage, it will not be
sufficient to carry the electrical load of the equipment
it is connected to and will cause nuisance breaker
tripping. Conversely, if a breaker is replaced with
one of higher amperage, it will not provide adequate
protection against an electrical malfunction and will
create a fire hazard.
Transducer Location
Fig. 4.5.1
TRANSDUCER
Rigging
Fig. 4.5.2
Rigging
Your boat has a rigging pull to allow the owner to
run new wiring for electronics. There is a pull cord
installed through a tube on the starboard side of the
fuel tank with the ends bundled and tied at either end
of the tube (Fig 4.5.2).
Tie another piece of nylon cord to the current
accessory wiring being run and use that for later runs.
1
RIGGING PULL
1
Transducer Location