58/104 Bosch Rexroth AG
Hydraulics training system WS290 | RE 00225-B/2.15
Transport and storage
8
Transport and storage
8.1
Delivery and unpacking
Chisel, plate shears (steel straps), knife (for plastic straps).
Transport the wooden box in an upright position to the unpacking location by
means of a forklift or lift truck.
Cut the steel straps through and remove them.
Remove the front side of the wooden box by using a chisel and place it aside.
Cut the plastic straps through and remove them.
Carefully lift the WS290 training system from the pallet by means of a forklift
and out of the box.
Carefully remove the cable ties and adhesive tapes and dispose of
them properly.
Dispose of the pallet and the wooden box properly or keep them properly for
later storage.
The WS290 training system may now be brought to its place of use.
Possible damage during transportation and defects shall be promptly recorded
and notified in writing by way of a notification of claim.
Required tool:
CAUTION
Risk of tilting of the WS290 training system! The center of gravity is possibly not
in the middle; depending on the attachment the center of gravity shifts!
Risk of injury during lifting and transportation!
During lifting and transportation, always move the training system carefully
with at least two people to avoid tilting.
Only lift the WS290 training system from the operator side by means of a
lift truck.
Create a corresponding support by means of wood due to the small contact
surface of the substructure.
Procedure
