Rexroth IndraDrive MPx-16 to MPx-18 Parameters
DOK-INDRV*-GEN1-PARA**-RERS-EN-P, R911328651
This documentation describes all parameters implemented in the firmware for drive controllers of the IndraDrive family. The
documentation supports the parameterization of the drive controllers.
●
FWA-INDRV*-MPx-16VRS
●
FWA-INDRV*-MPx-17VRS
●
FWA-INDRV*-MPx-18VRS
Rexroth IndraDrive MPx-16 to MPx-18 Diagnostics
DOK-INDRV*-GEN1-DIAG**-RERS-EN-P, R911326538
This documentation describes the diagnostics implemented into the following firmwares:
●
FWA-INDRV*-MPx-16VRS
●
FWA-INDRV*-MPx-17VRS
●
FWA-INDRV*-MPx-18VRS
It supports the operating crew as well as the programmer at troubleshooting.
Rexroth IndraDrive MPx-18 Version Notes
DOK-INDRV*-MP*-18VRS**-RNRS-EN-P, R911338658
The documentation provides a brief overview on the firmware function or the topic of the section.
Rexroth IndraDyn S MSK Synchronous Motors
DOK-MOTOR*-MSK********-PRRS-EN-P, R911296289
This documentation…
●
explains the features of the product, possibilities for use, operating conditions and operational limits of MSK motors.
●
contains technical data regarding available MSK motors.
●
provides information regarding product selection, handling and operation
xx
Corresponding edition
Tab. 1-6:
MTX micro documentation overview - Drive system: Commissioning
and project planning
1.4
Use of the safety instructions
1.4.1
Structure of the safety instructions
The safety instructions are structured as follows:
Burns and chemical burns due to wrong
battery treatment!
CAUTION
Safety alert symbol
Signal word
Consequences and
source of danger
Avoiding danger
Do not open the batteries and do not heat them over 80 °C.
Fig. 1-2:
Structure of the safety instructions
1.4.2
Explaining signal words and safety alert symbol
The safety instructions in this documentation contain specific signal words
(danger, warning, caution, notice) and, if necessary, a safety alert symbol
(according to ANSI Z535.6-2006).
Bosch Rexroth AG
DOK-MTXMIC-EASY*******-CO06-EN-P
10/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
About this documentation
