1
About this documentation
1.1
Validity of the documentation
Purpose
This documentation provides an overview of the components of the
IndraMotion MTX micro control system and supports the initial commissioning
with handling instructions and examples.
Overview on target groups and
product phases
In the following illustration, the framed activities, product phases and target
groups refer to the present documentation.
Example: The target group "Programmer" can "parameterize", "program, con‐
figure and simulate in the product phase Engineering" using this documenta‐
tion.
Presales Aftersales
Selection
Mounting
(assembly/installation)
Engineering
Commissioning Operation
Decommissioning
Product
phases
Target
groups
Activities
Design engineer
Programmer
Technologist
Process
specialist
Select
Prepare
Design
Construct
Mechanic/
electrician
Unpack
Mount
Install
Programmer
Commissioning engineer
Parameterize
Program
Configure
Simulate
Technologist
Process specialist
Optimize
Test
Machine
operator
Maintenance
technician
Service
Operate
Maintain
Remove
faults
Create
the NC program
Mechanic/
electrician
Disposal company
Dismount
Dispose
Fig. 1-1:
Assigning this documentation to the target groups, product phases
and target group activities
1.2
General information
The present manual supports you during the application/activation of various
control functions.
It focuses on the procedures required for the parameterization.
This requires that the hardware of CNC, drives, PLC and voltage supply units
are already integrated and checked according to your application documenta‐
tion including wiring and accuracy. This refers especially to all safety-relevant
features such as E-STOP circuits, release contacts, limit switches.
Ideally, the software of all Sercos drives is already commissioned. However,
this is not imperative, since the control is able to configure any drives connec‐
ted during startup via parameter download. Thus, the fitting initialization files
have to be available on the control.
To adjust the initialization files, have the corresponding documents available
(such as lists with the necessary Sercos parameter settings for all drives and
drive documentation).
For a better overview, all functions are assigned to different superordinate
topics (see "Table of Content").
DOK-MTXMIC-EASY*******-CO06-EN-P
Bosch Rexroth AG
5/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
About this documentation
