Bosch rexroth CytroForce-M, Operating Manual

Page: 38 / 85

38 / 85
Servo-hydraulic actuator
Accessories
Bosch Rexroth AG RE62270-B, 01.21
7.3 Installation conditions
7.3.1 Drive unit
●
The components mounted to the drive unit must not be subjected to any
mechanical loading (e.g. impact). The connectors and mating connectors
must be protected against such loads.
●
Make sure that the drive unit and particularly the attached components are
not damaged during the installation.
●
When installing the drive unit, always observe the ambient conditions speci-
fied in the technical data, see data sheet of the servo-hydraulic actuator.
●
The dimensions are shown on the installation drawing. When determining
the required space, take the installation orientation into account.
●
Please ensure during installation that in later operation sufficient air circula-
tion will be provided to prevent overheating.
●
The drive unit must be mounted on a ground with sufficient load bearing
capacity.
7.3.2 Drive controller
The drive controller and its accessory components have to be mounted
according to the project planning description of Rexroth IndraDrive systems,
see "Rexroth IndraDrive Drive Systems with HMV01/02 HMS01/02, HMD01,
HCS02/03, R911309636".
Generally, the drive controller produces an increased leakage current. If the
drive controller is to be operated with a residual-current circuit breaker, type B
or type B+ should be used. Otherwise, spontaneous triggering may occur.
7.3.3 Cable set
Information on the installation conditions for the motor power and motor
encoder cable is provided in
⮫
Chapter “Installing signal/control and power
cables” on page 42.
7.3.4 Installation orientation
●
The servo-hydraulic actuator may be installed in any position.
●
Information about the installation orientation of the drive controller is con-
tained in the project planning manual, see
⮫
Chapter 1.2 “Required and sup-
plementary documentation” on page 5.
Installation orientation of the accumulator:
For recommendations for the installation position of the accumulator, refer to
the documentation of the various accumulator types, see
⮫
Chapter 1.2
“Required and supplementary documentation” on page 5.
7.4 Accessories
Table 4: Accessories
Designation Material number
SY-SHA service kit R961013500
Observe the operating instructions R. 62249-B with regard to the maintenance
kit for servo-hydraulic actuators (SY-SHA).
Regarding accessories, please contact Bosch Rexroth Service for clarification;
see
⮫
Chapter 16.1 “Service and support” on page 77.