1
1
2
3
4
5
6
2
3
4
N.
O
.
CO
M
N.
C
.
A1
GND
A2
1
PIN
PIN
P102
P103
P104
WHITE
ORANGE
BROWN
GREEN
WHITE
ORANGE
BROWN
GREEN
YELLOW
BLUE
2
3
4
5
6
7
Figure 10.6: Alarm and relay connectors
1
4-pin Alarm
Connector (P102)
2
6-pin Alarm In
Connector (P103)
3
7-pin Relay Connector (P104)
Pin Description
Pin
Description
Pin
Description
1
Alarm Out 1
1
Alarm in 3
1
Alarm Out 4 Normally Open
2
Alarm Out 2
2
Alarm in 4
2
Alarm Out 4 COM
3
Alarm Out 3
3
Alarm in 5
3
Alarm Out 4 Normally Closed
4
Alarm Ground
4
Alarm in 6
4
Earth Ground
5
Alarm in 7
5
Analog Alarm 1
6
Alarm Ground
6
Analog Alarm 2
7
Ground
For in-ceiling mount only: Low Voltage TTL (3.3V) can also be used.
4
Connect the plugs to their mating connectors P103 and P102 in the Interface Box.
1.
To connect supervised alarms and relays, attach the appropriate wires to their terminals
on the P104 connector on the Pipe Interface Board. Refer to the Connection, page 71
chapter for more details on wiring alarms.
2.
Attach the lid to the Interface box:
Align the slots on the lid with the two posts at the rear of the Interface box.
Rotate the lid down.
Squeeze the ground clips, located at the front of the box, against the Interface box with
your fingers before closing the lid to ensure that the lid does not catch on the ground
clips.
Secure the lid to the Interface box by pushing the lid down until the clip on the lid
catches against the box.
Interface Box Connections
The following figure is a detailed illustration of the In-ceiling Interface box.
9.6
62
en | Installing the In-Ceiling Mount
AUTODOME 7000
2014.04 | 2.0 | F.01U.283.679
Operation Manual
Bosch Security Systems, Inc.
