Bomag BMP 8500, Operating And Maintenance Instructions Manual

Page: 35 / 128

Operation
BOMAG 35 BMP 8500
Fig. 32
l
Set the vibration toggle switch (Fig. 32) to po-
sition "0".
Fig. 33
l
Switch on the ignition (Fig. 33).
l
Under cold outside temperatures preheat for
approx. 10 seconds before starting.
!
Caution
Do not use any starting aid spray .
i Note
With the ignition switch in position "I" the machine
type code will appear in the display module for ap-
prox. 3 seconds.
The machine will emit a short horn signal. This in-
dicates that the machine is ready for operation.
i Note
If the horn does not sound, there must be fault on
the machine.
The control emits two short buzzer signals. This in-
dicates that the control is ready for operation.
i Note
If the buzzer does not sound, there must be a fault
in the control or the power pack of the control is
empty.
i Note
All normal work functions can only be operated
from a defined neutral position, i.e. the respective
control elements must be in rest position when
switching the sender on. If this is not true, the en-
gine cannot be started.
Fig. 34
l
Press the start button to start the engine(Fig.
34).
!
Caution
Run the engine warm for a short while before
starting work. Do not rev up a cold engine to
high idle speed/full load speed.
Starting with jump wires
l
Open the rear hood.
720153
0
720154
10s
720155
START