Bomag BMP 8500, Operating And Maintenance Instructions Manual

Page: 51 / 128

Operation
BOMAG 51 BMP 8500
l
If the value "9" is displayed and the function
key F
1
is pressed again, the display will jump
back to the value "0".
l
When pressing the function key F
2
the flashing
digit will move one digit to the right.
l
If the fourth digit in the display is flashing func-
tion key F
2
is pressed again to confirm the en-
try.
The desired function is now executed or the de-
sired value is displayed.
l
To cancel the display function you must either
enter code number "0000" or switch off the ig-
nition.
Setting ECO-mode
l
Enter " 5055 " to start the procedure.
l
Enter " 5057 " to switch off ECO-mode or
" 5058 " to switch on ECO-mode.
l
Enter " 5056 " to finish the procedure.
i Note
Input code " 5059 " is used to display the status of
ECO-mode.
Fig. 81
l
Switch off the ignition (Fig. 81).
4.15 Entering the machine type
code
!
Caution
After replacing the machine control (BLM) the
machine type code must be entered again.
The machine must not be operated with a
wrong type settings, as otherwise the correct
function of the control can no longer be as-
sured.
The code can only be entered when the engine
is shut down.
i
Note
A description of the procedure for entering code
numbers can be found in the chapter "Switching
ECO-mode on or off".
l
Enter " 7010 " to start the procedure.
This code number activates the function "Adjust-
ing machine type“. The display module now per-
manently shows code "
7010 ".
l
Enter " 7104 ".
The display module now permanently shows code
"
7104 ".
l
Enter " 7011 " to finish the procedure.
This code number confirms the entered machine
type.
After having confirmed the machine type the con-
trol switches off, restarts automatically after 3 sec-
onds and is then ready for starting.
i
Note
Whenever switching the ignition on the machine
type will appear in the display module for 3 sec-
onds.