Use of the control
5.2
Compressed airnet view
Page 40
BOGE compressor control airtelligence provis 3
To route a new compressed air line between two components:
1. Tap / click on the " Pipes " button.
2. Tap / click on first component.
The component is highlighted in red.
3. Tap / click on second component.
A compressed air line is shown between the two components.
To delete a compressed air line between two components:
1. Tap / click on the " Pipes " button.
2. Tap / click on the garbage can symbol
of the corresponding line.
The line disappears and is deleted.
Fig. 5.6: Changing the arrangement of components in DIN view
To leave the editing mode again:
●
Tap / click the
button.
The normal view mode of the DIN or 2D representation is active again.
In the editing mode for components:
Tap / click on the
symbol to change the direction of a connection line
from left to right and vice versa.
If a compressed air line already exists between 2 components, no second
compressed air line can be routed between these components.
Routing a new and deleting an existing signal line between 2 components
is performed in the same way as for compressed air lines, but the "Control"
button must be tapped / clicked first.
