52
TX/CX 4000
1. Choose legal-size paper on the
host and send the print job.
2. The printer’s operator panel
displays “Load paper, Tray #,
Legal.” Install the legal-size
paper tray in the printer, and
the printer will start printing.
You can press Continue on the
printer operator panel to print
on currently loaded paper and
not wait for the legal-size tray.
3. The System/38 sends margins
and other format specifications
to a printer only when they are
different from the previous
document or when the printer
has been turned off. To choose a
different size paper, you must:
a. Select a paper size in the
program.
b. Install the correct paper size in
the printer.
c. Power the printer off for about
five seconds, then power it back
on again.
4. Release the job for printing at
the printer’s controlling
workstation.
The line format screens in
DisplayWrite/36 (Command 20)
also permit you to select “Justify,”
which aligns the right margin. The
interface supports justification for
fixed fonts only. For best results
using justification, change the zone
width to 1 (instead of 6).
5.9.5 P
APER
D
RAWER
S
ELECTION
Hewlett-Packard
®
PCL mode:
Office/400 and DisplayWrite/36
allow the user to direct the print
output to one of three paper sources
regardless of whether the printer
actually has one, two, three, or more
trays to pull paper from. On the
host, these three theoretical paper
sources are called paper drawers. On
the printer, the actual paper sources
are usually called trays or bins. The
TX/CX 4000 acts as the matchmaker
between theoretical paper drawers
and physical trays available on the
printer.
You can access the paper drawer
feature of the TX/CX 4000 through
Host/PC download commands 13,
14, and 15 or through the front
panel of the TX/CX 4000.
To change the physical tray
assigned to the theoretical paper
drawer (#1, #2, or #3):
1. Select the paper-drawer number
through the TX/CX 4000’s front
panel or through a Host/PC
download command.
2. Select the number representing
the physical tray listed in the
printer’s manual.