105
TX/CX 4000
COMMAND 70: OVERWRITE EBCDIC (SCS/LU1) TRANSLATION TABLE
Custom substitutions defined by this command and stored in permanent
memory are written into the EBCDIC (SCS/LU1) to ASCII translation table.
VALUE
DESCRIPTION
XX
The EBCDIC character to be changed (in hex)
YY
The substitute ASCII character for the EBCDIC character
above
NOTES
Previously stored substitutions are automatically changed to the new
selection when the same hex location is specified in the EBCDIC table.
Previously stored substitutions are canceled if an ASCII hex sequence of
00 is specified.
Command Z99,0 must be used to store the substitutions in permanent
memory for them to be effective when the printer is next turned on.
The active EBCDIC (SCS/LU1) translation table prints out at the end of
the interface self-test summary.
Example:
&%Z70,7B,40/Z99,0
Prints a 40 ASCII hex (a @ symbol)
when the interface receives an
EBCDIC 7B (a # symbol). The
command is followed by a
command Z99,0 which stores the
active setup selections in
permanent memory.
COMMAND 71: OVERWRITE DSC (LU3) TRANSLATION TABLE
Custom substitutions defined by this command, and stored in the permanent
memory, are overwritten into the DSC (LU3) to ASCII translation table.
NOTES
This command functions similarly to Command 70 except the
substitutions are applicable to the DSC (LU3) translation table. Refer to
the Command 70 instructions.
The active DSC (LU3) translation table prints out at the end of the
interface self-test summary.