13
between the camera and the joystick controller.
•
You cannot use the RS-232 connections while you are us-
ing the RS422/485 connection.
Operating Multiple Cameras
Using RS-232,422/485
•
Using RS-232 (VISCA), you can connect to 7 cameras.
•
Using RS-422 (VISCA), you can connect to 7 cameras.
•
Using RS-485 (PELCO), you can connect to 255 cameras.
•
Using RS-485 (PELCO), all camera addresses must be
set up before the connection. You can set the camera
address by operating OSD menu, or by setting the Dip
Switch on the bottom of the camera. In this case, you can
use multiple control keyboards.
VISCA over IP Control
With VISCA over IP function, you can control the camera us-
ing VISCA protocol on a controller equipped with IP commu-
nication capabilities via LAN.
The communication specifications of VISCA over IP are fol-
lowings:
•
Interface: RJ-45 10/100M
•
Interface protocol: IPv4
•
Transport protocol: UDP
•
IP address: 192.168.100.100 By default
•
Port: 52381
•
Or you can use CAT5/6 T-568B Standard Ethernet cable
direct connect between the camera and the controller to
make RS485 connection by following the pin definition
below:
•
How to make RS485 multiple cameras connection with
RS485 standard serial port controller:
NOTE: For RS-232 VISCA control, this unit supports daisy
chain connection for using multiple cameras.
For control details, refer to Operating Instructions of control
keyboard/station software.
•
You need to match the communication speed (Baud Rate)
CAT5/6
Network Cable
RS485
Port
1. RX –
(Orange/White)
2. RX +
(Orange)
3. GND
(Green/White)
4. ---
(Blue)
5. ---
(Blue/White)
6. ---
(Green)
7. TX –
(Brown/White)
8. TX +
(Brown)
1
8
5. R –
4. R +
3. T –
2. T +
1. GND
VCC-CC45RS
RJ45 TO RS422/485
CONTROL CABLE ADAPTOR
5. R –
4. R +
3. T –
2. T +
1. GND
VCC-CC45RS
RJ45 TO RS422/485
CONTROL CABLE ADAPTOR
5. R –
4. R +
3. T –
2. T +
1. GND
VCC-CC45RS
RJ45 TO RS422/485
CONTROL CABLE ADAPTOR
RX +
RX –
TX +
TX –
GND
RS422
RS422 SERIAL PO
RT
ON CONTROLLER SIDE
HDMI Video Signal
3G-SDI Video Signal
VISCA Over IP Control
PoE Power
