NOTE THAT THE 10cm SPACINGS SHOWN ABOVE ARE FROM THE EDGES OF THE PODS, NOT
THE CENTRE OF THE PODS.
OxiBOSS INSTALLATION
READ THE DO’S AND DON’TS AND TAKE THE TIME TO INSTALL CORRECTLY.
OxiBOSS INSTALLATION
3.
Be sure to install the Tee piece in the correct
direction of the water flow, as per the arrow on
the Tee.
The Tee piece should be installed so that the
O
ORP Probe is within 30 of vertical. (See next
page)
1. Installing your OxiBOSS takes around 30
minutes.
4. The Probe/Injection Tee must be fitted on the
pipe that sends water back to the pool after it has
been filtered (the “Return Line”).
The OxiBOSS can be installed onto a new pool or an
existing pool with minimal pool preparation. Ensure
that the pool is correctly balanced, in particular the
pH.
TEE PIECE INSTALLATION
3. If installing it yourself you will need :
1. For 50mm (2") pipe, cut out a 6cm (2.5") section
of pipe sufficient for the Probe/Injection Tee
piece. For 40mm (1.5") pipe, where the reducing
bushes will be used, cut out a 7cm (2.75") section
of pipe.
NOTE:
Turn off all valves prior to fitting the T-piece
(avoid leaks), and turn them back on again before
switching pool pump back on.
!
PVC pressure glue and primer.
!
A fine tooth saw.
2. Alternatively engage a competent person to do
the job.
!
If a pH BOSS, Eco-Oxidizer and/or Bionizer is
installed, fit the OxiBOSS Tee LAST, AFTER the
pH Tee, Eco-Oxidizer Pod and Bionizer Pod .
!
If a Salt Chlorinator is installed, fit the OxiBOSS
tee AFTER the Salt Chlorinator cell.
2. If the Tee piece diameter is larger than the pipe
then use the 50mm to 40mm reducing bushes
provided by glueing them in place in the Tee
piece before fitting. The pipe should now fit
snugly into the Tee piece.
Filter
For sand filters,
glass or silica sand
media provides
optimum results.
Filter
Pressure
Pool
Pump
pH Tee
ORP Tee
10cm
min
10cm
min
Oxidizing
Pod
Ionizing
Pod
If a heater is
installed, then fit
the heater FIRST.
FLOW DIRECTION
FLOW DIRECTION
7
10cm
min
