AUTO / OFF BUTTON
O F F
: Unit will not
dose any sanitiser
again until this setting
is changed.
AUTO / OFF
is also the “
CANCEL
” button to exit
without saving changes in programming screens.
AUTO
:
Unit will dose
sanitiser when ORP is
outside the set point.
Press to alternatively select Auto or Off :
This range of this
setting is 2 to 25
minutes.
!
Use the
p
and
q
buttons to enter setting 2 to 25.
!
Press
PROGRAM / SET
save the new setting.
As a guide, use the following setting as a STARTING
point when the unit is first installed :
2....Up to 30,000 L / 8,000 Gallons
5....30,000 to 75,000 L / 8,000 to 20,000 Gallons
15..150,000 to 250,000 L / 40,000 to 65,000 Gallons
DOSE SETTING
Alternatively, press
AUTO / OFF
to cancel without
saving.
The dose setting is used to set the sanitiser pump
addition and waiting times, and are related to how
quickly the pool turns over the water. This is related
to both pool size, and pump/pipe setup.
In general, a smaller pool would use a lower Dose
Setting than a large pool. However other factors can
affect this, such as pool turnover time.
20..250,000 to 500,000 L / 65,000 to 130,000 Gallons
25..>500,000 L / 130,000 Gallons
10..75,000 to 150,000 L / 20,000 to 40,000 Gallons
If the OxiBOSS does not keep up with sanitiser
demand, and the Alarm sounds, increase the dose
setting by one step and check in 2 days.
If the alarm is tripped due to high ORP, reduce the
dose setting by one step and check in 2 days.
PROGRAMMING YOUR OxiBOSS
!
If no key has been pressed for 30 seconds, the unit will return to the normal readout display. Any changes
will not be saved.
PROGRAMMING YOUR OxiBOSS
!
Press the
PROGRAM / SET
button to move through each of the five user settings.
!
Use the
p
and
q
keys to change settings.
!
When changing a setting, press
PROGRAM / SET
after the desired setting is programmed to save the
changes and return to the normal readout display.
!
To quit any screen without saving changes, press
AUTO / OFF
to cancel.
11
